In the Load Combinations for PROFIS Engineering dialog select the desired Design Code: Select the column for which the base plate is to be designed. In RAM Foundation, invoke the Process - Export to PROFIS Engineering - Connect and Export command, or select the Export command on the tool bar: Invoking PROFIS Engineeringįirst, log in to PROFIS Engineering at as explained in the PROFIS Engineering and RAM Structural System Step-by-Step Guide, referenced above. The design of the footings is necessary in order to invoke the design of the base plates. Perform the design of the footings in RAM Foundation. Perform the analysis and design in the various modules as is typically done, including the analysis in RAM Frame. No special modeling is required in RAM Structural System, except that the foundations must be included in the model. PROFIS Engineering and RAM Structural System Step-by-Step Guide can be found at: Modeling and Analysis in RAM Structural System Hilti has prepared extensive documentation on the registration process and on the use of this feature. The limited version limits the number of Load Combinations to 10 as explained below, while the full version permits virtually any number of combinations.īefore proceeding, you need to create an account for PROFIS Engineering, if you have not already done so. However, RAM Structural System users that prefer not to obtain a subscription have access to a free limited version through this feature (you will first need to sign up for the 30-day Trial, after which you will be able to switch that to the free Standard version or to one of the subscription plans). The full PROFIS Engineering program is available by subscription through Hilti. A command has been added to the RAM Structural System to invoke PROFIS Engineering and to facilitate the transfer of material, geometry, and load information from the structural model to PROFIS Engineering for the design of base plates, particularly Frame column base plates. The Hilti PROFIS Engineering software provides several design capabilities, including the design of base plates and anchor rods. This document describes the use of this feature. The design of Frame column base plates can be obtained using the link to the Hilti PROFIS Engineering program in the RAM Structural System.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |